Hi,
I am trying to achive a "simple" task from my SCCM 2012 task sequence. I am trying to get full set of assesments using winsat.exe so as a result I get WEI score for all components on Windows 7 64 bit newly installed computers.
My TS basicaly runs command line with winsat.exe formal command
In smsts.log I get an error Not enough storage is available to process this command. (Error: 00000008; Source: Windows).In C:\Windows\Performance\WinSAT\winsat.log following error apear 15322933 (4320) - winsat\processwinsaterror.cpp:0095: ERROR: tried to read resource strings, unknown exception occured.
I have also tried to disable 64-bit redirection but TS also fails. Does anybody have an idea what am I doing wrong?
EDIT.
Here is the content of c:\Windows\Performance\WinSAT\winsat.log
68459307 (9532) - winsat\main.cpp:4301: Command Line = "WinSAT.exe" formal
68459307 (9532) - winsat\processwinsaterror.cpp:0095: ERROR: tried to read resource strings, unknown exception occured
68460024 (9532) - winsat\main.cpp:2505: > DWM not running.
68460523 (9532) - winsat\syspowertools.cpp:0983: > Read the active power scheme as '8c5e7fda-e8bf-4a96-9a85-a6e23a8c635c'
68460523 (9532) - winsat\main.cpp:2793: > power policy saved.
68460851 (9532) - winsat\syspowertools.cpp:1015: > Set the active power scheme to 8c5e7fda-e8bf-4a96-9a85-a6e23a8c635c'
68460851 (9532) - winsat\main.cpp:2814: > power policy set to maximum.
68461709 (9532) - d3d\dx9misc.cpp:1030: HRESULT = 8876086c
68461725 (9532) - d3d\dx9misc.cpp:1030: Error: Unable to create the D3D device
68461725 (9532) - d3d\dx9misc.cpp:1030: Error: Unable to check the capabilities of the video card because a d3d device could not be created
68461725 (9532) - winsat\logging.cpp:1763: ERROR: pahse enter/leave imballance
68461787 (9532) - winsat\syspowertools.cpp:1015: > Set the active power scheme to 8c5e7fda-e8bf-4a96-9a85-a6e23a8c635c'
68461787 (9532) - winsat\main.cpp:2855: > Power state restored.
68461787 (9532) - winsat\main.cpp:2873: > Not necessary to reenable EMD cache.
68462005 (9532) - winsat\main.cpp:4909: > exit value = 1.
I think that bold lines in winsat.log shows the real cause why Task Sequence if failing. What is interesting is that if I run winsat.exe formal from elevated CMD(Run as administrator) full set of assesments successfully runs.
