Hi,
I'm running SCCM 2012 and have recently installed the Windows 10 ADK and imported the WinPE 10 boot images. I still have the Windows 8.1 boot images on the PXE point for now whilst I test the WinPE boot images. I've injected the HP WinPE 10 driver pack NIC drivers into the x64 boot image using the SCCM console and then associated the boot image with my Windows 10 Task Sequence.
The problem I have is that oncemy HP 800 G2 reboots into the WinPE 10 boot image I have no network. The driver is not being loaded at boot. As far as I can tell the correct NIC driver has been injected though. If I bring up a command prompt inside WinPE and navigate to X:\Windows\System 32\Driverstore\Filerepository I can load the NIC driver using drvload.exe and pointing at the inf file which is in there.
Any ideas why the NIC driver is not being loaded at boot?
Thanks,
Jay